FREE SHIPPING AUSTRALIA WIDE
This bundled package comprising of a high quality stainless steel waterwall spillway and MULTI-COLOURS LED light bar allows you to create a projecting effect water feature and with lighting, ensures your water feature comes to life at night!
1 x LED Light Bar
- Material: High strength 316 stainless steel backing bar, LED Strip, Clear Resin filler
- Finish: Stainless steel - linished back, Clear LED face
- Dimensions: 900mm Long x 20mm Wide x 10mm High
- Power Input: 230-240V, 50Hz
- Power Output: 12V - 1670mA 20VA
- Lighting: 8 Colour variation LED with RGB Remote Controller included
- Accessories: 1 x CR2025 battery for remote controller included
- Cable Length: 5 metres
- Install Location: Typically to top of iEarth Spillways
- General LED light Bar Install Guide Included - Click here to view
- Warranty: 1 year limited Manufacturer Warranty Note: Cutting cables will void warranty.
1 x Water Feature Spillway Blade:
- Size: 900mm Long x 80mm Wide x 80mm High
- Lip: 35mm
- Material: 316 stainless steel
- Inlet Size: 2 x 25mm Female Treaded
- Inlet Entry: Bottom
- Warranty: 1 year Limited Manufacturer warranty
- General Install Guide Included - Click here to view
- Note - Always read Instruction Manual thoroughly before installation
*Note - As a guide for projecting effect, the Spillway should be installed no higher than 900mm from water level. The further the water drops, the narrower the water sheet widths become due to surface tension. The projection from the wall is approximately 100-200mm dependent on pump size and set up.
See also 'DIY Water Feature Kits' and 'DIY Lighting Kits' Category for Packages to suit.